15215 Autoloader ALE: conveyor roller motor overcurrent detected Platesetter_3244 Check conveyer cabling, motor and motor bearing (note ECO's). Check LUE (only reported if version 6 LUE installed) and check LUE/Conveyer cabling (note screen cable ECO). Resume if possible. If unable to continue, power off the machine and try again. If problem persists or recurrs, call Creo service. Conveyer roller motor PWM driver on LUE has reported an over current. The conveyer current is a digital input on the LUE board. The conveyer motor driver is also on the LUE board, the driver has a current limit which is set by fixed resistors on the LUE board. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:57 2008 PST